The usual problem:
Over the last few years a common fault showing up on various Peugeot and Citroen models is of the indicators not working properly.
Common symptoms include:
* A tendency to start indicating left, on cancelling the right indicator.
* Loose or floppy feel to the indicator stalk
* Indicators don't cancel, or operate unintentionally.
If your main beam flashes when indicating, or your airbag light is on, please contact us first as these faults are not included in our normal service.
Inside the indicator assembly (known as Com 2000) on the steering
column (if it's been made by DAV, not Delphi), there is a
small nylon plunger on a spring, which clicks in to hold the
indicator stalk in one of the three positions: left, centre, and
With use, this nylon plunger becomes worn and the result is a somewhat unpredictable indicator stalk.
A worn plunger
You can replace the whole indicator assembly costing several hundred pounds new, or maybe you can obtain a used one - but that would have to be exactly the same model - and quite probably will have a worn plunger also.
We offer 2 alternative cost effective solutions
* We can supply you with a new plunger for your DIY fix.
Sent to you within 1 working day by 1st class post.
* Our colleagues at QER can repair your DAV Comm 2000 for you.
Instructions of how to remove the indicators assembly from the steering column, and how to fit the new plunger are shown below.
Repair guide Stage 1
Remove steering wheel.
Whatever option you choose, first you need to remove the steering
This video is for a Peugeot 307. Other models may differ
Acknowledgements for video to blogsf89
Repair guide Stage 2
Strip down indicator assembly.
After removing the Com 2000 indicator assembly from the steering column.....
* It should
say "DAV" here. (#1)
(Some are also marked COM 2000, but not always.)
* Apply tape to stop boss turning.(#3)
If you are
taking the DIY route, continue as follows.
Otherwise, details of how to send for repair are at the bottom of the page.
* Unscrew 2 crosshead screws.(#2)
* Lever off the spring.(#4)
Prise two tabs as shown below........
And three tabs on the other side as shown below.....
Pull off the top.....to reveal the circuit board (below)
Disconnect the connectors and lift off the pcb,
to reveal the plunger at the indicator stalk end.
A close-up (below)
Lever the arm out of the housing.
Take care not to lose the spring inside the plunger
Here's the end of the indicator arm, once removed....
The plunger and spring....
Whilst you have it stripped down, thoroughly clean the switch contacts on the arm and the pcb.
If the steering column is moved following removal of the
indicator housing, or the boss of the housing is allowed to turn to
a different position, there is a risk that the internal ribbon will
snap on full lock after reassembly.
If you suspect either has moved significantly, set both your steering, and your indicator assembly to half-way before reassembly.
Ordering by Mail Order
Post us your faulty module - we normally repair, test and return
within 2 days.
To reduce the possibility of delays, please book in your order first by finding your product and booking on line on this site first.
Please pack in a stout cardboard box and send to
CA14 3YF UK
Enclose a copy of your online order, and ensure your phone no. and email are included.
Please state if you want the item returned if unrepairable.
Briefly describe the fault, as experienced.
If you are using Royal Mail, you can ask for a certificate of posting, guaranteeing you the goods' value up to around £30-£35 if the Post Office fails to deliver. - Post doesn't go astray often, but the certificate is a free alternative to registered or recorded delivery as a method of insurance.
You can also claim up to £10 compensation if your despatched goods are more than 4 days late: http://www.royalmail.com/compensation
Note to buyers from outside the European Union
On your customs declaration, please DO NOT give your item a value of anything above £1.
Otherwise, we will be forced to pay 25% import duty, and we will expect you to reimburse us for this!
Our happy customers
"Thanks worked a treat....";
(eBay ID j*******at)
"Well done guys! Received the item in under 24hrs, Part fitted and everything 100%."
(eBay ID b******11)
"Thanks item works perfectly as described."
(eBay ID m******12)
"Very good many thanks."
(eBay ID i********38)
Read more customer comments
Guarantee to our customers
All our products carry a full 1 year guarantee.
If a fault should develop at any time over the 12 month period, simply return for a free replacement or repair.
If, for any reason, you are unhappy with your purchase on receipt, simply return within 30 days for a full refund including P&P.